Knowledgebase: Setup
[QODBC-Desktop] Troubleshooting : Cannot change Optimizer Settings.
Posted by Jack - QODBC Support on 10 November 2014 02:12 PM

Problem Description:

When I run the program as an administrator, I can change the optimizer settings, but it never gets saved. Everything I rerun the Setup Screen, the grounds are back to the original settings, and my changes aren't saved. Do I have to make the changes in the setup screen every time before I can run my application that uses QODBC? Will it never save my settings for me? Or am I missing a step to get it to save the settings?


I think you have two DSN with the same name. One is User DSN & Other is System DSN. If you are modifying the DSN configuration from Start>>All Programs>> QODBC Driver for use with QuickBooks >> QODBC Setup Screen, then the change will affect System DSN configuration.

User DSN:


System DSN:


In this case, you need to remove one DSN. It is not advisable to use the same DSN name.

I kindly request you to please make changes in the DSN configuration from:

Start>>All Programs>> QODBC Driver for use with QuickBooks>> Configure QODBC Data Source>>Go To "System DSN" or "User DSN" Tab whatever you are using >> select DSN >> click "configure" & make changes as per your requirement & apply the changes.   

(0 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please complete the captcha below (we use this to prevent automated submissions).