Knowledgebase: Installation
[QODBC-Desktop] Activating QODBC still shows evaluation version in the QODBC Setup Screen
Posted by Rajendra Dewani (QODBC Support) on 10 December 2012 07:39 AM

Activating QODBC still shows the evaluation version in the QODBC Setup Screen. 

If you have activated QODBC with a purchased license CDKey and get the “Activation Successful” message and then run an application trying to use QODBC, you get the message to Purchase or Update QODBC. There is usually a permissions issue involved with newer operating systems such as Windows 7 or Windows 8. 

Please do the following:

Click Start -> All Programs -> QODBC Driver for use with QuickBooks -> QODBC Setup Screen

 

 

 

Right Click the QODBCSetup Screen icon and run as administrator and save. Then go back to the QODBC Setup Screen and Left Click to launch the Setup Screen. Go to the Activate Tab and then enter your CDKey on the Screen. You should then get an “Activation Successful” message.

 

 

Proceed to the About Tab, and it will show your license information (Serial Number and Licensed to:)

 

 

(1 vote(s))
Helpful
Not helpful

Comments (1)
D. Keith Jordan
28 January 2013 09:09 PM
I went through this process, over a year ago and activated it. Recently it shows up evaluation expired and read only mode. I put information back in, it said activation successful but didn't change info on the about. I even waited a few days for the info to go up into your system and update but still not working. Tried it again and says keys for the driver have been exhausted.
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the captcha below (we use this to prevent automated submissions).