Knowledgebase: Setup
[QODBC-Desktop] How to turn on the Trace Log
Posted by brad waddell on 12 March 2009 05:21 PM

How to Turn On the Trace Log

You can Turn on Detail Trace from: Start >> All Programs >> QODBC Driver for use with QuickBooks >> Configure QODBC Data Source

Go To "System DSN" Tab, Select "QuickBooks Data" DSN & click "Configure".

Navigate to "Message" Tab & enable "Detail Tracing (Slow)" option.

Switch to "Advanced" tab & Select "Add XML to Detail Trace Log"

Apply the changes. Close all the applications. ( If any of the application is already connected, QODBC will not start logging ) Connect again.

Messages Tab

      Messages allow you to review message logs from QODBC regarding errors and issues communicating with QuickBooks, clear these messages, and review messages produced by the QuickBooks qbXML SDK interface.

Instructions for Message Options

      Detail Tracing (Slow) creates a trace log of exactly what QODBC is doing in the background with the application and is used for debugging purposes. Make sure the log is turned off when not needed as these logs can use up large amounts of disk space.

      Display Optimizer Status Panel will display the progress of optimization of the data, this is especially helpful on large data files being reloaded in their entirety.

      Display Driver Status Panel when selected shows exactly what QODBC is doing when accessing the QuickBooks data and provides a good assessment of speed using optimized data and non-optimized data.

       Note: Be sure to uncheck this option when you no longer need the tracing log turned on as it will grow quickly and slow QODBC performance.

(205 vote(s))
Not helpful

Comments (1)
20 September 2012 12:27 PM
Fidinng this post. It's just a big piece of luck for me.
Post a new comment
Full Name:
CAPTCHA Verification 
Please complete the captcha below (we use this to prevent automated submissions).